visualfert.blogg.se - Sonicwall global vpn ipsecuritas

Select the Network tab and configure the following:.

Peer IKE ID: IP Address (address left empty) Local IKE ID: IP Address (address left empty) IPSec primary Gateway Name or Address: IPSec gateway IP address IPSec Keying Mode: IKE using Preshared Secret.

Select the General tab and configure the following:.

Ensure Enable VPN is selected in the VPN Global Settings section.

To create a firewall policy for the VNP traffic going from the SonicWall device to the FortiGate unit.ĭestination Address Name: FortiGate_networkĬreate the address object for the FortiGate unit to identify the FortiGate unit's IP address for the VPN Security Association (SA).Ĭonfigure the VPN settings for the VPN tunnel connection.

Select Create New and set the following:.

To create a firewall policy for the VPN traffic going from the FortiGate unit to the SonicWall device

Enter the SonicWall IP address and subnet.

Enter the name for the address, for example SonicWall_network.

Enter the FortiGate IP address and subnet.

Enter a name for the address, for example FortiGate_network.

**Quick Mode Identities: add source and destination networks as SonicWall will require this in building the Security AssociationsĪdd an the source and destination addresses and add an internal to external policy that includes these source and destination addresses to permit the traffic flow.

Leave all other settings as their default. Select Advanced and enter the following:.(default values shown can be changed by admin) Select Create New and enter the following:.

SonicWall device running SonicOS Enhanced 3.1.0.11Ĭonfigure the FortiGate unit Configure the Phase1 and Phase 2 VPN settings.FortiGate unit running FortiOS 3.0 or higher.Depending on the hardware and firmware used, some settings may vary. This article describes the basic settings to set up a VPN connection between a FortiGate unit and a SonicWall device.